Salt spray corrosion test chamber wi

A. Prepare before the test;

1. At the bottom of the studio should add distilled water to the bottom of the liquid level float float low water lights went out.

2. The seal groove around the box body upper test before adding distilled water, shoulds not be too full, in order to close the lid after the salt fog not spillover is preferred.

3. The air saturator (stainless steel) in distilled water or deionized water, the water level height is transparent liquid level gauge tube upper 4/5 position or low water lights, add distilled water, should open the upper part of the saturator inlet valve, when added to the specified level, must close the valve.

4. Will the mist removal pipe and a drain at the back of the box body from outside.

5. The sample of box frame in place, and put the sample in a test box.

2. The experimental work

In, from work or succession to detect salt solution allowance (though this trial please add salt solution), check the saturated barrels and water (water bottom please add water)

2. Air compressor must row a oil every day

3. After the test

1. Shut down after the power supply

2. Take out the sample, clean with tap water samples, such as rating sample after completely dry

3. Cleaning test chamber (the following times to do the test and the test time interval is not long, do not need to clean)